View Full Version : Turn signal replaced but still not working
Mike V
December 9th, 2011, 02:25 PM
I replaced the Turn signal switch but it still not working. When I unplugged the switch the lights blinked like the switch was tuned to the hazard mode. Which I don't have. When I pluged in the new switch the lights kept blinking in the same manor. Any suggestions would be appreciated.
Thanks,
Mike
Aggressor
December 9th, 2011, 08:56 PM
Mike - I just solved a nagging problem which plague my switch for a long time.
!st of all the ground wire not attached to the ground tab and 2nd was a stray chunk of solder which fortunately fell out while I examined it.
- Geary
Mike V
December 9th, 2011, 09:37 PM
Thanks Geary, I'll look under the dashboard.
m
RJacobsen
December 10th, 2011, 08:17 AM
When I unplugged the switch the lights blinked like the switch was tuned to the hazard mode. Which I don't have.
Mike
Umm, are you sure you dont have a separate switch under the dash for the Hazard mode?
Mike V
December 18th, 2011, 09:46 PM
Yet again, I feel rather foolish. I do have a hazard switch under the dash. Oh I also found an extra key that was placed there by the previous owner. Everything works great now. Thanks for all the help everybody.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.