scott h
August 2nd, 2006, 05:28 PM
i have a tremec 5-speed with hydraulic throwout bearing. the clutch engages just about as soon as i lift the pedal. Mc leod the T.O. manufacturer says i need a minimun of 1 inch to1 1/4 inches of piston rod travel with a 3/4 bore master cyl. I can get the rod to move just under an inch before it bottoms out. possible causes are the pedal set-up will only allow that much travel or possible bad Master. i was considering a bigger bore or longer throw master. The bearing seems to be installed at the correct setting though i could try to adjust it if necessary. Does anyone have any similar experiences or some advice please! Oh yeah i have bled the hecjk out of it too! no changes.