RJacobsen
September 28th, 2005, 09:03 PM
After gettin the car home I set about desiding where to start. The floor and footboxes attracted the most attention so it made sence to start there. I did contact the Weavers about getting the parts but desided to rebuild it from scatch. My fiberglassing experience comes from my growing up in Montana. Dad was a snowmobile dealer and the weekend outings with my 4 brothers were hard on fiberglass hoods among other things. Anyway here are some shots of the floor and footbox area.
http://www.uniquecobra.com/uploaded/rjacobsen/Look Ma No floor.JPG
http://www.uniquecobra.com/uploaded/rjacobsen/Rear panal cut out.JPG
The back panal, rear sections of the floor and tunnel were cut out but not discarded. They are visable in the next two shots.
http://www.uniquecobra.com/uploaded/rjacobsen/drivers side missing.JPG
http://www.uniquecobra.com/uploaded/rjacobsen/passenger side missing.JPG
To be continued....
Rod
Roseville, Ca.
289 FIA #9152 "The Flintstone Cobra"
http://www.uniquecobra.com/uploaded/rjacobsen/Look Ma No floor.JPG
http://www.uniquecobra.com/uploaded/rjacobsen/Rear panal cut out.JPG
The back panal, rear sections of the floor and tunnel were cut out but not discarded. They are visable in the next two shots.
http://www.uniquecobra.com/uploaded/rjacobsen/drivers side missing.JPG
http://www.uniquecobra.com/uploaded/rjacobsen/passenger side missing.JPG
To be continued....
Rod
Roseville, Ca.
289 FIA #9152 "The Flintstone Cobra"