View Full Version : t/5 trans
COBRAGAR
October 17th, 2003, 05:54 AM
has someone build a bracket to install a hydrulic slave cylinder to a t/5 trans if yes please post pictures
dmiller
October 17th, 2003, 12:28 PM
ok, will do.
dmiller
October 17th, 2003, 12:28 PM
ok, will do.
dmiller
October 17th, 2003, 12:34 PM
slave cyl on a small block with tremec 5 speed.
http://www.uniquecobra.com/uploaded/dmiller/DSCN1748-email.jpg
http://www.uniquecobra.com/uploaded/dmiller/DSCN1749-email.jpg
http://www.uniquecobra.com/uploaded/dmiller/DSCN1750-email.jpg
dmiller
October 17th, 2003, 12:34 PM
slave cyl on a small block with tremec 5 speed.
http://www.uniquecobra.com/uploaded/dmiller/DSCN1748-email.jpg
http://www.uniquecobra.com/uploaded/dmiller/DSCN1749-email.jpg
http://www.uniquecobra.com/uploaded/dmiller/DSCN1750-email.jpg
dmiller
October 17th, 2003, 09:15 PM
my drawing of the clutch bracket, made it from 3/4 material, what i could find, sawed rather than flame cut.http://www.uniquecobra.com/uploaded/dmiller/clutchdrwg-email.jpg
dmiller
October 17th, 2003, 09:15 PM
my drawing of the clutch bracket, made it from 3/4 material, what i could find, sawed rather than flame cut.http://www.uniquecobra.com/uploaded/dmiller/clutchdrwg-email.jpg
COBRAGAR
October 18th, 2003, 12:51 AM
thank for the information . looks very nice
COBRAGAR
October 18th, 2003, 12:51 AM
thank for the information . looks very nice
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.