View Full Version : drive shaft safety loop
dmiller
April 19th, 2003, 11:36 AM
does this bolt up to the two angle iron pieces that are welded to the frame? are these two angle iron weldments the "flanges" that are discussed in the assembly manual?
thanks
doug
weaver
April 19th, 2003, 11:53 PM
Yes but keep in mind the drive shaft is offset in the tunnel so attach the loop close to the drive shaft on the pass side, leave a 1/4" space between the loop and the shaft. You have plenty of room on the driver side.
Alan Weaver
weaver
April 19th, 2003, 11:53 PM
Yes but keep in mind the drive shaft is offset in the tunnel so attach the loop close to the drive shaft on the pass side, leave a 1/4" space between the loop and the shaft. You have plenty of room on the driver side.
Alan Weaver
dmiller
April 20th, 2003, 05:59 AM
thank you.
doug
dmiller
April 20th, 2003, 05:59 AM
thank you.
doug
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.